Authors CurseForge

For my purposes just having a simple interface to show all incoming heals is fine. For those people who prefer a VisualHeal style display with time relevent information, they are going to be disappointed.

Just had a repeat of the following spam when using r569:

<>

Got the following using v5.0.2.5:

<>

The following got through using v5.0.1.0

<>

using r548 the following got through:

<>

not directly after, there was about 20 seconds delay between each message.

Using v5.0.0.0 the following got through:

<>

and from the same spammer

<>


A third message (different again) from the same spammer triggered BadBoy to report them.

Just had the following message get through while using v4.3.1.1

<>

Something to note for whenever you get v5 out the door.

That information can only be retrieved from auras that have been applied to a unit, UnitAura.

The description on wowwiki of the parameters returned from UnitAura should give you what you need.

As a further update to the issue I am seeing (or not seeing) with incoming heals from tranquility:

In a random instance, while levelling my mage, the druid healer used tranquility rank 5 and I received incoming heal events associated with it. On my feral druid casting Tranquility rank 5 I get no incoming heal events.

I'm not sure when it started happening, but I recently noticed that incoming heals from Tranquility are not being shown.

Using my own healcomm interface and some instrumented code I am not seeing any healing events fired for Tranquility.

I have even tried backing up my Interface and WTF folders and just using Shadowed Unit Frames as an alternative, and that also fails to show incoming heals from Tranquility.

The testing I have done is with my Druid with a Feral spec and LibHealComm-4.0 v1.6.3.


Has anyone else seen this issue?

The initial discussion was based on the fact that some people wanted to see all incoming heals, but did not want to send any data to anyone else. That is a specific case where I'm glad the authors of LibHealComm disagreed with.

This is different from the situation you are trying to describe archangel.

While I understand what you are saying, something just didn't 'feel' right about the incoming heals on penance.
To test it out I recorded a video of a penance cast with the combat log showing to see the sequence of events.

When casting on a friendly NPC I saw this sequence:

- cast begins
- LHC gives 6k heal incoming
- initial tick hits target
- LHC gives 3k heal incoming
- 2nd tick is cast
- 2nd tick hits target
- LHC shows no incoming heals
- 3rd tick is cast
- 3rd tick hits target

When casting on myself the sequence is the same, apart from the first 3 steps being instant.

It looks like the final penance tick is not being counted as an incoming heal.

I normally play as holy spec on my priest, but recently I've changed from shadow to disc as my offspec.

I can't say I've noticed it before but using v1.6 of LibHealComm-4.0 I am not seeing the incoming penance heals as expected.
When I target myself I only get 1 tick as incoming heals (approx 3k) that is cleared after the first tick hits, the 2nd and 3rd tick have no associated incoming heal value.
When I target someone else I only get 2 ticks as incoming heals (approx 6k) that decreases as each tick hits, the 3rd tick has no associated incoming heal value.

Does this happen for anyone else?


edit: It looks like travel time may be a factor. when I lag a bit and cast on myself then I get an incoming heal value of approx 6k, but it gets reduced to 3k when the first tick hits which is almost instant. I would still expect the last tick to be shown as incoming heals though.