• 0

    posted a message on PitBull_TotemTimers
    Is this module still functioning? I can't bring up the config with /pbtt, don't see it listed under "modules" in pitbull, and see no options for it under "player -> other". I am playing a low-level shaman. Thanks!

    EDIT: Nevermind, seems to be working now. I update daily frequently (sometimes a couple times a day) so I'm guessing it was just a problem with the build before the current one (71655).
    Posted in: Unit Frames
  • 0

    posted a message on Cartographer_Mining re-enables itself
    I use cartographer mining, but generally prefer not to see the nodes as they clutter my map, so I allow the addon to load but keep it disabled unless I need the information. This morning, I noticed some odd behavior. I un-check "enable" under mining in cartographer, and the nodes disappear as expected. When I open cartographer again a few moments later, the nodes have returned and mining is enabled. I updated the modules from WowAce updater a few minutes ago, but the problem persists. Stranger still, it doesn't re-enable immediately - if I open cartographer again right after I disable mining, it stays gone. It seems to take more than a minute for it to enable again. Is this a bug, or something I'm doing wrong? What can I do to make it work properly? Thanks in advance.
    Posted in: Map/Minimap AddOns
  • 0

    posted a message on Bartender3 - Action Bar AddOn for WoW 2.0
    Thank you, Seerah - I don't know why it didn't occur to me to check there. I'll just blame it on it being past my bedtime... ;) I appreciate the help.
    Posted in: General AddOns
  • 0

    posted a message on Bartender3 - Action Bar AddOn for WoW 2.0
    Monolit - I'll look into the macro issue a bit more.

    On another note - I'm having a small issue with tooltips. When I mouseover a spell on my action bar, it displays only the spell name and rank instead of the full spell tooltip (which is visible when mousing over a spell in the spellbook). I realize this is probably intended functionality, as I'm sure most of you don't care to see the tooltip...but I'm curious - is there a way to get the full tooltip back? Is this even a bartender issue? Thanks in advance.
    Posted in: General AddOns
  • 0

    posted a message on Bartender3 - Action Bar AddOn for WoW 2.0
    Quote from Monolit »

    since noone asnwer my question before i have to ask again , because the problem still exists and i can't find a solution:

    is there any way to change barX to barY with macro command (using bartender3)? or some other way which will allow me to bind 1 key for swapping 2 barrs at the same time (not modifiers).

    What I want here is to swap 2 bars (1,2) to bar 3 and 4 with just ctrl+mouse wheel down, and swap back with ctrl+mw UP.

    I would like to see any reply on this issue. It should be possible but i can't figure out the way to do this, so any help will be appreciated


    If you want to switch one way with ctrl + mw up and the other with down, you'd need two macros to bind separately.
    Macro 1:
    /changeactionbar [actionbar:1] 3
    /changeactionbar [actionbar:2] 4
    
    and Macro 2:
    /changeactionbar [actionbar:3] 1
    /changeactionbar [actionbar:4] 2

    Those *should* do want you want - basically the first says if you have actionbar 1 showing, and you hit the button, it will change to action bar 3 and so on. An easier way, imo, would be:
    /changeactionbar [actionbar:1] 3; 1
    /changeactionbar [actionbar:2] 4; 2

    This should change actionbars 1 & 2 to 3 & 4 on the first button press, and back again on the 2nd. Good luck!
    Posted in: General AddOns
  • 0

    posted a message on FuBar_RegenFu
    I'm having the same problem as Moxie - I can't get RegenFu to display. I've tried the most recent versions (from wowace updater) as well as the last major release (from curse, i think). Can't access the addon at all.

    EDIT: I was able to get it to load by using MCPFu - a FuBar plugin that allows in-game loading of addons.
    Posted in: FuBar AddOns
  • 0

    posted a message on XLoot
    @northernplato - thanks :)
    Posted in: General AddOns
  • 0

    posted a message on XLoot
    Having a minor problem with xloot monitor - hopefully someone can help me out. Everything seems to be working correctly, however the xloot monitor shows double the quantity of the item that was looted. The green number to the left is correct, but not the actual loot list. I updated all xloot-related addons today from the svn, but this didn't resolve the problem. I'm not getting bugs or errors or anything, though.

    Somewhat unrelated - I've read that several of you have disabled loot spamming in the chat frame - how do I do that?

    Thanks in advance for the help.
    Posted in: General AddOns
  • To post a comment, please or register a new account.